On Tue, Nov 29, 2011 at 4:22 PM, Maurice Bouchard <firstname.lastname@example.org>wrote:
> ugh! Sorry about all the exposed HTML. Not sure why it happened, but I
> am switching to plain text.
> Looking a little more closely at the output from autogen.sh, it look like
> the Lua library is missing (and required, apparently). autogen.sh may not
> be finishing and therefore not creating the Makefile.in
It is better to use devtool that the plain autogen.sh . I don'use MacOS
but you can try ./devtool eastham (check devtool.conf
for the targets and the associate configure options)
> From: Maurice Bouchard <email@example.com>
> To: "firstname.lastname@example.org" <email@example.com>
> Sent: Monday, November 28, 2011 2:41 PM
> Subject: RPM v5.4 - config.status: Missing 'Makefile.in'
> I am trying to build rpm v5.4 for Mac OS X 10.6.8 but am stalling at
> config.status. The last three messages in config.log are:
> config.status:1751: creating po/Makefile.in
> config.status:1751: creating Doxyfile
> config.status:1737: error: cannot find input file: Makefile.in'
> and, in fact, there is no Makefile.in in the rpm source directory (where I
> checked out the code) but there is a Makefile.am. I built "configure" with
> autogen.sh and used all the correct GNU tools (autoconf, automake,
> libtoolize, and gettextize). Autogen.sh runs without errors as far as I can
> tell. I run configure as follows:
> sudo ./configure CC="gcc -arch i386" CXX="g++ -arch i386" (I need the CC
> and CXX flags otherwise configure coughs up on libbeecrypt)
> It goes through all the checking just fine and starts to create some
> output. It successfully creates po/Makefile.in and Doxyfile but then gives
> the error message above.
> Has anyone seen this? Any advice will be most appreciated.
> Maury Bouchard
> Simmons College
> RPM Package Manager http://rpm5.org
> User Communication List firstname.lastname@example.org
Received on Tue Nov 29 17:08:34 2011